Stitches

I am looking for some help on digitizing embroidery designs. I have a gap in my design where the lines are.?

I really appreciate everyones help. I am using the Husqvarna/Viking 3D Software. Thanks,

Public Comments

1. Have you done a test stitch yet? The gap may be there for a reason. What kind of software are you using? Different softwares use different methods. If you can, stretch the fill area to the line, or simply move the line in to the fill - in your digitizing software.
2. hi there , Well if you are not able to do your design as per your requirements .you can take my help on that . you can mail me your artwork at rishabhkhanna@hotmail.com and tell me all the details u require . i assure you a quick turnaround a good quality and resonable cost i hope that solves ur purpose thanks and regards
3. There can be a few reasons for this... - one could be your pull compensation. If you increase it to .2 that should take care of it. - If the gap is on the stitchout and not in the design software, it could be that you are using the wrong type of stabilizer for your fabric. Correcting this could help. - Sometimes the order your colours are stitched in can contribute to this problem...try ordering your colours so that the last colour stitched is the one that is beside the outline. There are several Yahoo Groups for each type of digitizing software which, if you are a member, are happy to help with these type problems and give great advice.
4. hello, i am a digitizer. hope i can help you. pls contact me and tell me what problems you met. looking forward to your reply. fisher
5. if it is a digitizing design, I can do it for a test free for you. I assure you a fast turnaround. mysite:,www.global-emb.com would you have a look at this for your consideration?Or sent me your design directly.